- General Diagnosis – 12 questions
- Ignition System Diagnosis & Repair – 8 questions
- Fuel, Air Induction & Exhaust Systems Diagnosis & Repair – 9 questions
- Emissions Control Systems Diagnosis & Repair (Including OBD II) – 8 questions
- Computerized Engine Controls Diagnosis & Repair (Including OBD II) – 13 questions
Make sure you are prepared for your ASE A8 Engine Performance. McRee Learning Center can help.



ASE A8 Engine Performance - Sample
Quiz Summary
0 of 10 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Results
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
-
Thanks for completing your free sample quiz. Make sure you pass your ASE A8 Exam the first time. Take the full U Test Prep Exam today to achieve your highest possible scores and reach your goals.
Purchase now and pass the first time!
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 10
1. Question
A no-start condition is being diagnosed on a vehicle equipped with a distributor ignition using a remotelymounted ignition coil. The coil wire is removed from the center of the distributor cap and a spark tester is used to check for spark. There is spark out of the coil but no spark is available to any of the spark plug wires. Technician A says the rotor could be defective. Technician B says the spark plugs are fouled. Which technician is correct?
CorrectIncorrect -
Question 2 of 10
2. Question
Which of the following is LEAST likely to result in a rich air fuel ratio?
CorrectIncorrect -
Question 3 of 10
3. Question
All of the following are necessary to complete the injector cleaning process EXCEPT:
CorrectIncorrect -
Question 4 of 10
4. Question
Which of the following should be the first step in diagnosing an engine performance concern?
CorrectIncorrect -
Question 5 of 10
5. Question
On an oscilloscope raster display of the secondary ignition system, the most likely cause of an 8 to 10 degree dwell variation between cylinders would be:
CorrectIncorrect -
Question 6 of 10
6. Question
All of the following are true of ignition module replacement EXCEPT:
CorrectIncorrect -
Question 7 of 10
7. Question
Two technicians are discussing OBD code P0301. Technician A says the P in the code stands for powertrain. Technician B says the 0 in the code means it is manufacturer specific. Who is correct?
CorrectIncorrect -
Question 8 of 10
8. Question
An engine is idling too fast when the engine reaches operating temperature. Technician A says the engine could have a vacuum leak. Technician B says that the throttle linkage or cable could be stuck. Which technician is correct?
CorrectIncorrect -
Question 9 of 10
9. Question
Two technicians are discussing a four wire oxygen sensor. Technician A says this oxygen sensor contains a heater circuit. Technician B says the engine's control module uses the oxygen sensor's voltage signal to adjust the air fuel ratio in closed loop. Who is correct?
CorrectIncorrect -
Question 10 of 10
10. Question
An EFI engine stalls and then starts back up. Sometimes it takes several tries to start. Technician A says a loose connection at the crankshaft position sensor would result in this condition. Technician B says an open at the crankshaft position sensor would result in this condition. Who is correct?
CorrectIncorrect